Do I need a releasing agent for molds when using your epoxy?

Release agents are not necessary however they do help on some occasions. If your molds are made from silicone, HDPE plastics, and rubbery plastics, then there is no need for a release agent. 

The Epoxy Resin Store
Address: 540 Crane Street Unit A Lake Elsinore, CA 92530 
Phone: (951) 677-0400
Email: support@theepoxyresinstore.com
Hours of Customer Service: 8 AM - 4 PM (PST) Mon - Fri 
Closed: Sat - Sun 
We respond within 1 business day

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us